In this video we run through the basic wiring of a set of pixels, a Baldrick controller and a Meanwell RSP-320-12 12v Power Supply. We hook them all up detailing what we’re doing and why and run a test mode on the pixels at the end of the video.
This video has not been sponsored, but iLightThat did supply the Baldrick board at no cost and I do not have to return it.
Baldrick Boards & Power Supplies available from:
Austraila:
Hanson Electronics: https://www.hansonelectronics.com.au/
Europe:
Pro Pixeler: https://propixeler.nl/
USA:
Gilbert Engineering USA: https://gilbertengineeringusa.com/
Wired Watts: https://www.wiredwatts.com/
UK:
Build A Light Show: https://buildalightshow.com/
Affiliate Links to products used (I do get a small return from products purchased using these links):
Amazon.com (USA)
Workpro Style Scissors: https://amzn.to/42IgyUh
10 AWG Teflon Wire: https://amzn.to/4hRUwmr
IEC Mains Cable (Various Lengths): https://amzn.to/3WScSvo
Amazon.co.uk (UK)
WorkPro Scissors: https://amzn.to/4aRvZLL
10AWG Teflon Wire: https://amzn.to/4jSUJaw
Pro-Elec IEC Cable (2m): https://amzn.to/40XWg6S
Timeline:
0:00 Introduction
0:52 Connecting Pixels to Controller
5:13 Wiring Phoenix Connector
10:52 Connecting Controller to Power Supply
14:26 Forks & Ferrules
20:12 Power Supply to Mains (110v or 220v)
24:04 LRS-350 Input Voltage Switch
24:24 Review Connections before plugging in!
25:10 Ethernet Connection
27:05 Plugging In
28:10 PC Connecting to Baldrick
29:30 Setup Output
30:27 Start Tests!
31:06 Reset Config & Retest!
32:00 Review what’s been covered in the video
35:00 Wrap-Up!